9 m elliptical rotating pole, EA-K120K-9, internal halyard, bracket/gallows arm, tilting mount, crank

9 m elliptical rotating pole, EA-K120K-9, internal halyard, bracket/gallows arm, tilting mount, crank has the item number 8515.75 and is characterised by nominal height 9 m, outrigger, elliptical design. This version is available from 1.357,79 € incl. VAT.

9 m above ground – which means the pole remains highly visible even across larger commercial sites and car parks. We recommend portrait flags of 450 to 650 cm in length, or landscape formats around 150 × 300 cm. The pole is set into a ground socket cast in concrete; the stated 9 m are the visible height above ground, so the overall length is correspondingly greater. You will find the matching foundation plan in the „Instructions“ tab. The outrigger arm holds the flag clear of the pole so it stays readable even when there is no wind.

Flagpoles with 360° rotating bearing and hoistable bracket/gallows arm.
Aluminium pole tubes with an elliptical cross-section, optimised structurally and aerodynamically. Besides the greatest possible stability, this tube shape has the advantage of the lowest possible noise emission in strong winds.

Thanks to the structural and aerodynamic optimisation of the pole tubes, the poles guarantee stability in accordance with DIN EN 1991-1-4/NA for wind zone I when flying a flag, up to a nominal height of 12 m. For nominal heights up to and including 9 m, stability for wind zone 2 is guaranteed as standard – likewise when flying a flag.

The benefit of the rotating bearing of the pole tubes is that both the flag and the hoisting device turn "out of the wind" at the same time. This prevents the flag from wrapping or tangling in turbulent wind and rain.

Equipment:
Nominal height / total length 9.00 m

Aluminium pole tube, material EN AW-6082T6, silver anodised E6/EV1, profile cross-section 120 x 140 mm, elliptical, aerodynamically and structurally optimised, with a moulded groove for the internal hoisting device, FlagLift crank hoisting device, self-locking, removable hand crank, stainless steel halyard, lockable with a flush-fitting stainless steel cover with lever lock, pull slide, flag fabric holders (6 pcs.), telescopic bracket 100/160 cm, keder flags can be hoisted, pole tube mounted on a flange shaft with rotating bearing, triangular base flange size 314, safety hinge, base section with 3 adjusting anchors M16 for vertical pole installation, pole tube stable when flying a flag in accordance with DIN EN 1991-1-4/NA wind zone II, pole weight 77 kg


Technical data:
Nominal height (NH): 9.00 m, total length (GL): 9.00 m, profile cross-section: 120/140
Stability in accordance with EN 1991-1-4/NA is met

Flag finishing:
Side tape with hooks. Hollow hem along the top edge of the fabric, Ø 30 mm, open on both sides. The topmost hook must be sewn on directly below the hollow hem. Hook spacing max. 1.00 m, max. fabric width 1.50 x 4 m. The flag is slid onto the bracket tube by its hollow hem. The topmost flag carabiner hooks into the hole of the long slide, the remaining carabiners into the eyelets of the flag fabric holders. The flag weight with stainless steel carabiner is hooked into the lowest flag fabric holder and thus prevents the flag from riding up in gusts.

Tilting mount, flange shaft on anchor cage, safety hinge, adjusting bolt